Refrigerant Lines For Condenser, Removing and Installing

Refrigerant Lines For Condenser, Removing And Installing

Disconnecting
- Discharge refrigerant circuit
- Remove noise insulation
- Remove entire front bumper







- Remove bolts - A - (tightening torque 20 Nm).
- Remove refrigerant lines from condenser.

NOTE: Seal open lines and connections at condenser with suitable caps (to prevent dirt and moisture).

Installing
Install in reverse order, paying attention to the following:







- After attaching, check routing of refrigerant lines - A -. They must be inserted in brackets - B - provided and not make contact with other components.
- Replace O-rings - B - and - C - .
- Check type of seal at connections and refrigerant lines (must be designed for same type of seal).
- Evacuate and recharge refrigerant circuit.