Telephone Receiver Cradle, Creating Openings on Center Console

Telephone Receiver Cradle, Creating Openings on Center Console

The center console is delivered as a replacement part without holes for cell phone receiver cradle. The holes must be made later.

- Remove center console:

• Center Console, Removing and Installing, USA, through October 2004, Refer to => [ Center Console, through October 2004 ] Storage Compartments and Covers

• Center Console, Removing and Installing, USA, from November 2004, Refer to => [ Center Console, from November 2004 ] Storage Compartments and Covers.

- Create holes with the following dimensions.





a 10 mm
b 6 mm
c 22 mm
d 101 mm
e 25 mm
f 16 mm
g 5 mm
h 8 mm

- Clip the threaded hole piece, Refer to => [ (Item 1) Threaded Hole Piece ] Storage Compartments and Covers from behind into center console and tighten holder to 1.5 Nm

• After installation, check whether the glove compartment will open