Bumper, Mounting to Shock Absorber

Bumper, Mounting to Shock Absorber
Up to Vehicle Identification Number (VIN) 400 000

Note:
Shock absorber is self-adjusting, meaning it can compensate bearing tolerances in height between bumper and shock absorber when screwing in the socket head bolt.
This holds and secures the front bumper automatically in the previously adjusted position when screwing in the socket head bolt -1-.
In vehicles as of Vehicle Identification Number (VIN) 400 001, the self-adjusting height compensation has been discontinued.





1 - Socket head bolt
23 Nm

2 - Lower carrier bushing
Plastic part pressed into adjusting screw.
No replacement part available

3 - Lower adjusting screw
Before assembling bumper, screw in completely but do not tighten.
Left-hand thread
No replacement part available

4 - Lower threaded bushing
Secured against falling out with securing pin.
No replacement part available

5 - Securing pin
No replacement part available

6 - Shock absorber
Removing and installing => [ Shock Absorber ] Front Shock Absorber.

7 - Upper threaded bushing
Secured against falling out with securing pin.
No replacement part available

8 - Upper adjusting screw
Screw in completely before assembling bumper.
Right-hand thread
No replacement part available

9 - Cover
Removing and installing => [ Front Bumper ] Front Bumper.

10 - Nut
Belongs to crossmember delivery casing.

11 - Upper carrier bushing
Plastic part pressed into adjusting screw.
No replacement part available

12 - Cross member
Removing from cover and installing => [ Front Bumper Crossmember ] Service and Repair