Garage Door Opener Control Head: Service and Repair

HomeLink Garage Door Opener

=> [ Garage Door Opener Control Head ]

=> [ Garage Door Opener Control Module, through 10.04 ]

=> [ Garage Door Opener Control Module, from 11.04 ]

Garage Door Opener Control Head

Removing

- Use small screwdriver to pry control head out of sun visor at locations indicated - arrows -.





- Disconnect electrical connection.

Installing

Install in reverse order of removal.

Garage Door Opener Control Module, through 10.04

CAUTION!
• Switch off all electrical consumers.

• Switch ignition off and remove ignition key.

Removing

- Remove front bumper cover Removal and Installation.

- Remove bolt - 2 - and disengage retainer.





- Remove module - 1 - from bumper cover.

- Disconnect electrical connection.

Installing

Install in reverse order of removal, noting the following:

- Install front bumper cover Removal and Installation.

Garage Door Opener Control Module, from 11.04

CAUTION!
• Switch off all electrical consumers.

• Switch ignition off and remove ignition key.

Removing

- Remove front bumper cover Removal and Installation.

Vehicles with headlamp washers

- Release clamp and remove hose - 1 -.





- Turn hose connector - 2 - on headlamp washer system upward.

Continued for all

- Release retaining clips - 4 - and fold back retainer - 3 -.





- Remove module - 2 - from bumper cover.

- Disconnect electrical connection - 1 -.

Installing

Install in reverse order of removal, noting the following:

- Install front bumper cover Removal and Installation.