FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2007 >> A4 Quattro Cabriolet (8HE) L4-2.0L Turbo (BWT) >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Shifter A/T >> Service and Repair >> Overhaul >> 09L, 6 Speed AWD A/T

09L, 6 Speed AWD A/T



Selector mechanism, disassembling and assembling - 09L, 6 Speed AWD A/T

Note:
^ Removing and installing securing spring for locking cable.
^ If selector gate or selector housing are faulty the entire selector mechanism has to be replaced. The two components cannot be adjusted using workshop tools.





Disassembling
- Shift selector lever to position "S".
- Remove Shift lock solenoid N110 - item 7 -.
- Unbolt and then unclip selector gate - 12 - from selector housing - 14 -.
- Release pivot pins - 5 - and - 19 - and pull them out sideways.
- Unclip retaining clips - 2 - and - 16 -.
- Pull off retaining clip - 17 -.
- Swivel locking lever - 11 - upward as far as it will go.
- Pull selector lever - 6 - together with bushings - 3 - and - 15 - and Tiptronic locking levers - 4 - and - 18 - downward out of selector housing - 14 -.





Assembling
- Make sure that selector lever is still in position "S".
- Swivel locking lever - 11 - upward as far as it will go.
- Insert selector lever - 6 - into selector lever housing - 14 - from below.
- Install Tiptronic locking levers - 4 - and - 18 -, and bushings - 3 - and - 15 - onto selector lever.
- Push selector lever - 6 - together with bushings into selector lever housing - 14 - and position with retaining clip - 17 -.
- Engage retaining clips - 2 - and - 16 - on selector lever housing.
- Press pivot pins - 5 - and - 19 - into selector lever - 6 - until they engage.
- Check that the pivot pins are engaged in the Tiptronic locking lever.
- Install Shift lock solenoid N110 - item 7 -.
- Clip selector gate - 12 - onto selector housing - 14 - and tighten to 0.4 Nm.





Removing and installing securing spring for locking cable

Removing
- To remove locking cable lift spring slightly at top - arrow B -.
- Disengage spring from retainer lug - arrow C - and lift out.

Installing
- Insert spring from above - arrow B - and engage under retainer lug - arrow C -.
- Align spring so that it lies level in groove - arrow A -.
- To install locking cable, lift spring slightly at the top - arrow B -.
pro multis Credits:Operation CHARM About Operation CHARM