Rear Window Regulator

Rear Window Regulator

- Remove rear side trim.

- Remove window shaft strips => [ Window Weather-stripping ] Removal and Replacement.





- Mark position of nuts - 3 -, adjusting screws - 6 - and bolts - 8 -.

- Remove nuts - 3 -.

- Remove bolts - 8 - and remove cover - 2 -.

- Loosen Convertible Top Control Module (J256) on right side of vehicle => [ Convertible Top Control Module ] Convertible Top Control Module.

- Loosen nuts - 7 - from adjusting screws - 5 -.

• The lower nuts - 6 - can remain on the adjusting screws - 5 -, the upper ones must be removed.

- Disconnect window regulator motor connector.

- Remove window regulator - 5 - from side panel - 1 -.

Installation is reverse of removal.

Tightening torques => [ Rear Window Regulator Assembly Overview ] Rear Window Regulator Assembly Overview.