Ball Bearing For Input Shaft, Transmission Cover, Bearing Housing and Selector Shaft, , Assembly Overview

Ball bearing for input shaft, transmission cover, bearing housing and selector shaft, removing and installing, assembly overview, 01X, 6-Speed Front-wheel Drive M/T





1 - Torx bolt, 35 Nm
^ 3 (Qty.)
^ Apply locking fluid AMV 185 101 A1 when installing

2 - Guide sleeve
^ With seal

3 - O-ring
^ Always replace

4 - Dished spring

5 - Circlip
^ Note thickness
^ Re-determining thickness

6 - Ball bearing

7 - Circlip
^ Note thickness
^ Re-determining thickness

8 - Locking bolt, 45 Nm
^ 2 (Qty.)
^ Apply locking fluid AMV 185101A1 when installing

9 - Dowel sleeve
^ 2 (Qty.)
^ Insert in transmission housing
^ Remove and install with drift 3121

10 - Selector shaft with selector cylinder

11 - O-ring
^ For selector shaft cover
^ Always replace
^ Lubricate with gear oil

12 - Cover for selector shaft
^ With Back-up light switch F4

13 - Bolt, 24 Nm
^ 3 (Qty.)
^ Apply locking fluid AMV 185101A1 when installing

14 - Back-up light switch F4 -20 Nm

15 - Pin
^ For selector shaft stop
^ Insert in transmission housing
^ Installation position: groove on threaded pin points toward selector shaft cover

16 - Dowel sleeve
^ 2 (Qty.)
^ Insert in bearing housing
^ Remove and install with drift 3121

17 - Transmission cover

18 - Bolt, 35 Nm plus an additional 90° 1/4 turn
^ 12 (Qty.)

19 - Bearing housing

20 - Transmission housing
^ With differential and flange shafts

21 - Oil drain plug, 45 Nm

22 - Oil filler plug, 45 Nm