Locking Lever (From VIN 8E_6A156500), Removing and Installing

Locking lever (from VIN 8E_6A156500), removing and installing - 01J, Continuously Variable Transmission (CVT)

Overview

Overview:

1- Locking cable
2- Retaining clip
3- Locking cable eye pins
4- Locking cable bracket
5- Bolt, 10 Nm
^ For adjusting locking cable

Removing

Note:
^ Do not kink locking cable.

CAUTION!
Observe procedures for disconnecting battery.

- Disconnect Ground (GND) wire at battery.
- Remove storage compartment on drivers side.
- Remove steering column trim.
- Remove A/C system operating unit.
- Remove ashtray in center console.
- Remove cover for shift mechanism.
- Turn ignition key into driving position "ignition on".
- Place selector lever in position "P".





- Lift retaining clip -2- from interlock lever and pull locking cable -1- out of ignition/starter switch.





- Raise retaining tab -A- and remove locking lever in direction of -arrow- from locking cable eye pins.

Installing
Installation is in reverse order of removal, note the following:





- Route locking cable without kinks under wiring harness -arrow A- and behind instrument panel brace -arrow B-.
- Turn ignition key into driving position "ignition on".





- Insert locking cable -1- into ignition/starter switch.
- Check interlock lever -2-.
- Bring ignition/starter switch into locking position "ignition off".
- Check whether selector lever is in position "P".





- Slide locking cable in opposite in direction of -arrow- onto locking cable eye pins.
^ The retaining tab -A- must engage over locking cable
- Adjust locking cable.
- Observe procedures for connecting battery.