9-Pin Relay Carrier

9-Pin Relay Carrier

Removing





- Switch off ignition and remove ignition key.

- Remove driver's storage compartment.

- Remove nuts - 3 - and remove Vehicle Electrical System Control Module (J519) with wiring connected.

- Remove 9-pin relay carrier - 4 -.

- Unclip fuse panel at 9-pin relay carrier.

- Detach relays and control modules and then unclip appropriate relay carrier.

• Check the exact assignment of 9-pin relay carrier in the current wiring diagram Wiring diagrams, Troubleshooting & Component locations.

Installing

Install in reverse order of removal, observing the following:

- Install driver's storage compartment.

Tightening Specifications