Solenoid Valve, Removing and Installing

Solenoid valve, removing and installing







Removing
Follow cleanliness rules.
- Remove hydraulic pump.
- Remove bolts - 3 -.
- Remove solenoid valve - 2 - upward out of hydraulic pump - 1 -.

Installing

CAUTION: Solenoid valves may only be installed in hydraulic pump in activated (energized) condition. Initiate output diagnostic test mode (DTM) and activate the affected solenoid valve for this.







- Connect electrical harness connector - 1 - to solenoid valve - 2 -.
- Initiate output diagnostic test mode and activate solenoid valve to be installed
- Insert activated solenoid valve - 2 - in hydraulic pump - 3 -.
- Tighten bolts - arrows -.