Flange Shaft Sealing Ring (Final Drive Installed), Installing

Installing





Left sealing ring, installing
- Lightly lubricate outer circumference of new sealing ring and drive in as far as stop.
- Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1.





Right sealing ring, installing
- Lightly lubricate outer circumference of new sealing ring and drive in as far as stop.
- Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1.

Continuation for both sides:
- Clamp flange shaft in vise, using jaw protectors.





- Press circlip with new circlip - A - out of flanged shaft groove.
- Drive in flange shaft using a synthetic head hammer.
- Replace flanged shaft/drive axle seal (remove protective foil and push seal into joint).
- Install drive axle.
- Checking gear oil in rear final drive.