Transmission Temperature Sensor/Switch: Service and Repair

Wiring harness with 8-pin connector and integrated Transmission fluid temperature sensor - G93 -, removing and installing, 09G, 6 Speed A/T





Overview:
A - Connector, 8-pin
B - Wiring harness to 8-pin connector -A-

Note:
^ Be familiar with the rules for cleanliness when working on the automatic transmission.
^ General repair instructions.

Removing
- Disconnect battery:
- Remove oil pan.
- Remove ATF screen.
- Remove valve body

With transmission installed:





- Disconnect 8-pin connector -B- from transmission connector.

Continuation for all:
- Remove securing bolt of 8-pin connector on outside of transmission housing.





- Remove connector from transmission housing and carefully guide wiring harness -C- after it.

Installing
Installation is performed in the reverse order; note the following:
- Install new O-ring on connector.
- Coat O-ring with ATF.
- Press connector with O-ring installed to limit stop in transmission.
- Tighten bolt for connector to 5.5 Nm.