Tie Rod Ends, Removing and Installing

Tie rod ends, removing and installing

Removing
- Loosen nut on track rod end.

Note: Leave nut screwed several turns onto tie rod end to protect thread.





- Remove tie rods from steering arms using puller Kukko 129/0.





- Counterhold tie rod end - A - with a 24 mm spanner when loosening and tightening lock nut - B -.
- Loosen lock nut - B -.
- Remove nut from tie rod end
- Remove tie rod end.

Installing
- Installation is carried out in reverse sequence.
- Tighten lock nut - B - to 50 Nm.

Make sure that rubber boots are not twisted.