Primary Connector With Special Connector Systems

Primary Connector With Special Connector Systems

Procedure

NOTE: If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts.







Faston contacts:
- Guide release tool (that fits terminal housing) into release channel on terminal housing - arrow -.
- Grasp contact at wire and push gently into terminal housing.

NOTE: By pushing contact in direction of terminal housing, contact retaining tabs are lifted off the housing shoulder and can be released using release tool.







- At the same time, push release tool in direction of terminal housing and pull released contact out of terminal housing - arrow -.
- Remove release tool after removing contact from housing.







GT 150/280 contacts:
- Guide release tool (which fits terminal housing) under retaining tab into terminal housing.
- Push tool into terminal housing until it stops - arrow -.







- Contact is ejected from the terminal housing.

- Remove release tool after removing contact from housing.







Contacts without retaining tabs:
- Insert release tool under retaining tab of terminal housing.
- Push release tool through until it stops by gently lifting - arrow -.







- Contact is ejected from terminal housing.

- Remove release tool after removing the contact from housing.