Center Mounted Brake Lamp: Service and Repair

High Mount Brake Light - Coupe, Removing And Installing

CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

Removing

NOTE:
- Do not operate brake pedal.
- In the event of a malfunctioning LED, the complete high-mount brake light assembly must be replaced.

- Open rear lid and unclip/remove tray.







- Slide high mount brake light assembly -2- forward and remove from rear window. If necessary, gently lever the assembly out on the left and right edges using a screwdriver.
- Pull electrical connection out from retainer clip.
- Disconnect electrical connection -1-.

Installing
- Install in reverse order of removal.
- Ensure electrical connection is securely located in retainer.
- Confirm brake light function.