01V,01VA Transmission

Locking Cable

Removing

• Do not kink locking cable.

- Place selector lever in position "S".

CAUTION!
Note the instructions for disconnecting the battery.

- With the ignition switched off, disconnect the battery Ground (GND) cable (GND) - arrow -.





- Remove the driver side storage compartment.

- Remove the steering column cover.

- Remove the A/C control head.





- Remove the ashtray in the center console.

- Remove cover for shift mechanism. Refer to => [ Shift Mechanism Cover ] Shift Mechanism Cover.

- Turn ignition key to run position (ignition on).

- Place selector lever in position "P".





1 - Locking cable

- Lift retaining clip - 2 - from interlock lever and pull locking cable - 1 - out of ignition/starter switch.

- Lift securing spring - 4 - for locking cable and pull locking cable support bracket - 5 - on shift mechanism sideways and disengage locking cable eye.





1 - Locking cable

Installing

Install in reverse order, paying attention to the following:

- Route locking cable kink-free behind instrument panel strut - arrow -.

- Turn ignition key to run position (ignition on).

- Insert locking cable - 1 - into ignition/starter switch.

- Check interlock lever - 2 -.

- Turn ignition/starter switch to locked position ("ignition off").

- Check whether selector lever is in position "P".

- Engage locking cable eye in pins - 3 -.

- Raise retaining spring - 4 - slightly.

- Slide locking cable mounting bracket - 5 - from right into selector mechanism until retaining spring - 4 - engages.

- Adjust locking cable. Refer to => [ Locking Cable, Adjusting ] Adjustments.

- Install cover for shift mechanism. Refer to => [ Shift Mechanism Cover ] Shift Mechanism Cover.

- Install the ashtray in the center console.

- Install the A/C control head.

- Install the steering column cover.

- Install the driver side storage compartment.

- Heed appropriate instructions for work to be performed following battery connection.