Transmission Input Speed Sensor, With Hydraulic Control E18/2

Transmission Input Speed Sensor, with Hydraulic Control E18/2

• On a transmission with hydraulic control "E18/2", Transmission Input Speed (RPM) Sensor (G182) is a Hall sensor (secured behind valve body on transmission housing).

Removing

- Remove valve body. Refer to => [ Valve Body ] Valve Body.

- Remove bolt - B -.





- Remove Transmission Input Speed (RPM) Sensor ( G182) - A - from transmission.

Installing

Installation is in reverse order of removal, note the following:

- Electrical connector - C - for Transmission Input Speed (RPM) Sensor (G182) is clipped into valve body mount after installing valve body.

- Install valve body. Refer to => [ Valve Body ] Valve Body.

- Fill ATF. Refer to => [ ATF, Changing or Filling after Repairs ] .

Tightening specification