Wiring Harnesses and Connectors Repair Information
Wiring Harnesses and Connectors Repair Information
CAUTION!
• Do not solder components of the vehicle electrical system.
• Do not perform repairs on heat-shrink sleeves. Route a new wire along the faulty wire if necessary.
• Shielded wires, e.g. on speed sensor and knock sensors, are NOT to be repaired. These wires must be replaced complete if damaged.
• Only use yellow wires for repairs to wiring. Mark location of repair with yellow insulating tape.
• Yellow wiring and locations with yellow insulating tape on wiring harness designate a previous repair.
•