Drive Plate With Overload Protection, Removing And Installing

Drive Plate With Overload Protection, Removing And Installing

- Remove compressor.

Removing







- Remove bolts - A -.

NOTE: Use commercially available band wrench (with webbed band) to provide support at drive plate - C -.

Installing
- Install drive plate with overload safeguard - B - to drive plate - C -.
- Insert and hand-tighten bolts - A -.
- Check run-out of drive plate - B
- Tighten bolts - A - (tightening torque 10 Nm).
- Check run-out of drive plate - B - again