Center and Rear Mufflers, Separating

Center and Rear Mufflers, Separating

• A separating point has been provided in the connecting pipe for individual replacement of the center or rear muffler.

• The separating point is marked by depressions around the circumference of the exhaust pipe.

Special tools, testers and auxiliary items required

• Chain Pipe Cutter (VAS 6254)

Procedure

• For the correct tightening specifications, refer to => [ Exhaust System Overview ] Exhaust System Overview

- Separate exhaust pipe at a right angle at separating point - arrow 2 - using the (VAS 6254).






- Position clamping sleeve - 4 - at the side markings - arrows -, - 1 - and - 3 - when installing.

- Install clamping sleeve so that bolt end does not project beyond lower edge of clamping sleeve - arrow -.






• Threaded connection points to the rear.

- Install exhaust system free of stress. Refer to => [ Exhaust System, Aligning ] Procedures.