Engine Accessory Bracket: Service and Repair

Accessory assembly bracket, removing and installing

Special tools, testers and auxiliary items required





^ Locking Pin T10060A





^ Spring-type clip pliers VAS 5024 A

Removing





- Disconnect electrical connector - 1 -.
- Disconnect intake connection - arrow - using spring-type clip pliers VAS 5024 A.
- Remove engine cover upward and out in direction of - arrow -.





- Remove cover from above battery, by pressing release buttons - arrows -

CAUTION! Observe measures when connecting battery.





- With ignition switched off, disconnect Battery Ground (GND) strap - arrow -.





- Remove EVAP canister with connected lines upward - arrow - out of retainer and lay it aside.

Note: Before removing ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt under operating conditions.





- Pivot ribbed belt tensioner in direction of - arrow - to relieve tension on ribbed belt.





- Secure tensioning element using Locking Pin T10060A.
- Remove ribbed belt.





- Remove ribbed belt tensioner - arrows -
- Discharge refrigerant circuit.
- Remove generator.
- Remove sound insulation.





- Remove right noise insulation fasteners - 1 to 3 -.
- Remove A/C compressor.





- Remove accessory assembly bracket - bolts - 1 to 6 -.

Installing
Installation is in reverse order of removal, note the following.
^ Tightening torques refer to Ribbed belt, assembly bracket, assembly overview





- Tighten bolts in sequence - 1 to 6 -.
- Install Generator.
- Install A/C compressor.
- Install ribbed belt.
- Connect battery.