Fiber Optic Cable, Separating From Wiring Harness Connector

Fiber Optic Cable, Separating From Wiring Harness Connector







Removing
- Unplug fiber-optic cable connection from control module or device.
- Use small screw driver to release catch in fiber optic cable connector - arrow -.







- Pull fiber optic cable basic module - 2 - out of connector housing - 1 -.







CAUTION:
- Make colored dots to mark assignment of fiber optic cable - 5 - to corresponding sockets in basic module - 1 -.
- Note the arrows - 3 - for allocation on the base module "IN" and "OUT".

- Release secondary catch - 6 - (blue pin) using a small screwdriver - arrow -.
- Release retaining tab - 2 - and remove fiber optic cable - 5 - with brass connector pin - 4 - from basic module - 1 -.

Installing
Install in reverse order of removal, observing the following:
- Install fiber optic cable in line with markings.







NOTE:
- Seal open harness connector - 2 - for fiber-optic cable using Protective Cap For Cable Connector VAS 6223/9 - item 1 -.
- Protective cap prevents contamination of or mechanical damage to end face of fiber optic cable which would impair signal transmission.