Coil Connector With Slip Ring, Removing and Installing

Coil Connector With Slip Ring, Removing And Installing

Drivers airbag unit and steering wheel removed

- Pull out steering column and tilt downward as far as it will go.







- Remove screws - 1 - (2x), tightening torque 2.8 Nm.
- Remove grip - 2 -.







- Remove two Phillips-head screws - arrows -.
- Tightening torque 0.6 Nm
- Remove upper steering column switch trim - 1 -.

When installing, insert upper section into hooks on lower section, swivel downward and secure with screws.







- Remove screws - 2 - (2x). Tightening torque 0.6 Nm
- Remove hex socket head bolt - 1 -.
- Tightening torque 0.6 Nm
- Remove lower steering column switch trim - 3 -.







- Separate connection - 1 -.
- Release locking tabs - arrows - and pull coil connector with slip ring off steering column switch.

NOTE: The steering wheel must be in the center position (wheels in straight-ahead position) when the coil connector and slip ring are removed and installed.