Left Rear Level Control System Sensor -G76-, Removing and Installing

Left Rear Level Control System Sensor -G76-, Removing And Installing

Removing (front-wheel drive)

CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

Sensor (front-wheel drive) is mounted above the rear axle.







- Disconnect electrical connection -2-.
- Remove nut -4- and detach linkage.
- Remove both bolts -3- and remove control system sensor -1- together with bracket.
- By removing both socket head bolts (3mm) at level control system sensor -1-, it can be removed from the bracket.

Installing
Install in reverse order of removal.

Removing (all-wheel drive)

CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

Sensor (all-wheel drive) is mounted above the rear axle at the component carrier.







- Disconnect electrical connection.
- Remove nut -3- and detach linkage. Linkage is mounted to the crossmember with a bracket and two nuts.
- Remove both socket head bolts -4- (3mm) at level sensor and remove it from bracket -1-.
- If necessary, bracket -1- can be removed from component carrier by removing both bolts -2-.

Installing
Install in reverse order of removal.