Lubrication System Components, Part I

Lubrication system components, Part I





1 - Oil pump

^ With pressure relief valve (12 bar)
^ Before installing, check that both dowel sleeves for centering oil pump/cylinder block are fitted.
^ Replace pump if there is scoring on moving surfaces and gear teeth
^ Tightening torque for oil pump cover to oil pump housing: 10 Nm

2 - Chain sprocket for oil pump

^ Note correct position
^ Sprocket can only be fitted on oil pump shaft in one position

3 - 25 Nm

4 - Drive chain for oil pump

^ Mark running direction before removing.
^ Check for wear.

5 - Sealing flange

^ Apply silicone sealant D 176 404 A2 before installing.
^ Replacing crankshaft oil seal on pulley end

6 - 15 Nm

7 - Chain tensioner

^ Tighten to 15 Nm
^ Do not disassemble
^ Note installed position
^ Pre-tension spring and engage before installing
^ If spring is broken replace entire chain tensioner.

8 - Chain sprocket

9 - Dowel sleeves

10 - 15 Nm

11 - Suction line

^ Clean strainer if soiled.

12 - O-ring

^ Replace

13 - Baffle plate

^ Only install with oil pump installed

14 - 15 Nm

15 - 15 Nm

16 - Oil pan

^ Apply silicone sealant D 176 404 A2 when installing

17 - Seal

^ Replace

18 - Oil drain plug, 30 Nm