Satellite Receiver, On-Board Diagnostic (OBD)

DTC Table For The Satellite Receiver

NOTE:
- Before replacing the components identified as faulty, check the wiring and connectors to these components as well as the ground connections according to the wiring diagram.
- After repairing and testing the system function, always check the DTC memory again with the vehicle Diagnostic Operation System VAS 5051 and erase.
- All static and sporadic DTCs are stored in the DTC memory:
- A DTC is indicated as static if it is present for at least 2 seconds. If the DTC is no longer present, it is stored as sporadic.
- After switching on the ignition, all stored DTCs are set as sporadic and only if a fault reappears after the diagnostic check, it is stored as a static DTC.
- If a sporadic fault does not occur again during 50 operating cycles (ignition on at least 5 minutes, vehicle speed above 30 km/h), the DTC is erased.