HID Headlamp Ignition Coil, From 09.07

HID Headlamps

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

• Adjust the headlamps after performing any work that could have affected their adjustment.

HID Headlamp Ignition Coil, from 09.07

Removing


Danger to life due to high voltage.

• Observe usage and safety information for gas discharge headlamps.

- With ignition switched off, disconnect battery ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Loosen locking bolt - 1 - a few turns.





- Remove appropriate front wheel.

- Remove appropriate front wheel housing liner.

- Release retainer tabs - arrows - and detach gas-discharge lamp housing cover from headlamp housing.

- Disengage the retaining clip - 1 - and tilt it to the side.





- Rotate the HID headlamp ignition coil - 3 - counterclockwise - arrow - to automatically release the electrical connector - 2 -.

- Remove the HID headlamp ignition coil.

• Harness connector must only be connected with ignition coil installed.





- Check if recess in housing of ignition coil for gas discharge lamp and recess in pressure ring align completely with each other - arrows -.

- Attach ignition coil for gas discharge lamp to headlamp and fasten clockwise until stop.

• Ignition coil must turn freely.

• Arrow on housing points upward.

- Close the retaining clip on the HID headlamp ignition coil.

- Connect harness connector.

- Close housing cover and secure with screw.

- Install front wheel housing liner.

- Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal and tighten nut. ] Battery, Disconnecting and Connecting.