Rear

Removing And Installing Door Lock







1. Rear doors
2. Rear door lock
- Assembly carrier and window frame removed.
- Lock cover removed .
- Disconnect electrical harness connectors to door lock.
- Disengage Bowden cable - 5 - from release lever - 6 - .
- Remove multi-point bolts - 2 - .
- Remove door lock downward out of door.
3. Grommet
- Press into assembly carrier.
4. Bowden cable
- To interior door mechanism.
- Secured by clipping into door lock - arrow - .
- Engage in interior door mechanism .
5. Release lever
- Insert Bowden cable into operating lever in direction of arrow.
- Swing Bowden cable 90� and clip it in door lock.
6. Assembly carrier
- Guide cables for interior door mechanism, closing assist through assembly carrier as shown and press in grommets.
7. Bowden cable
- Only for vehicles with closing assist
- Pull through assembly carrier and engage in closing assist motor.
- Engage Bowden cable in motor for closing assist .
8. Gasket
- Slide gasket sideways into door lock.
9. Socket-head bolt
- 20 Nm






Engaging Bowden cable in interior door mechanism
- When installing door trim, cable - 2 - must be engaged into interior door mechanism - 1 - from top downward as shown.
- Clip cable - arrow - into interior door mechanism.






Latch cover
- Removed before removing door lock.
- To remove, unclip from door - arrows - .