Side Luggage Compartment Trim, Removing and Installing

Side Luggage Compartment Trim, Removing And Installing







1 - Luggage compartment side trim
Removing
- Remove luggage compartment floor covering covering.
- Remove rear cross panel trim.
- Open upper fasteners - 2 -.
- Remove storage compartment - 3 -.
- Remove socket.
- Raise securing ring - 4 - (4x).
- Loosen two cross-head bolts - 5 - in each of securing rings.-Unfasten clips - 10 -.
- Remove luggage compartment side trim.
Installing
Install in reverse order of removal. Note following:
- On completion of installation, fold rear lid rubber seal over luggage compartment side trim - 1 -.
2 - Upper fastener
- Qty. 2
- For storage compartment - 3 -
3 - Storage compartment
4 - Securing rings
5 - Bolt
- Qty. 2 per securing ring
- Tightening torque: 5 Nm
6 - Speed nut
- Qty. 3
- Always replace after removing
7 - Rain channel trim
- Removing rain channel trim from luggage compartment side trim/assembling.
8 - Cap
- Assignment Parts List
- Unclip/clip in
9 - Lower fastener
- Engaged with luggage compartment side trim
10 - Clips
- Qty. 2
- Replace if damaged
11 - Ventilation grille.