Front Parking Aid Sensor, With Double Grille

Parking Aid

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Front Parking Aid Sensor, with Double Grille





• Component location: In the bumper cover at - arrows -.

Removing

Outer Sensors

- Remove bumper cover.

Inner Sensor





- Switch off ignition and remove ignition key.

- Remove bolts - arrows - on top of lock carrier and below Audi rings.

- Spray silicone-free lubricant into the gap between radiator grille and bumper cover.





- Pull the radiator grille - 1 - first in the places marked with - arrows A - out of the bumper cover.

- Next, pull the radiator grille down at - arrows B - out of the bumper cover.

Continuation for All Sensors





- Disconnect electrical harness connector - 1 - at sensor.

- Press both catches - arrows - to the side and press the sensor inward from the outside.

Installing

Install in reverse order of removal, observing the following:

Outer Sensors

- Install bumper cover.

Inner Sensor:

- The radiator grille must engage into the bumper cover audibly.

Tightening Specifications