Rearview Camera System

Rearview Camera System

=> [ Rearview Camera System Control Module ]

=> [ Rearview Camera ]

Rearview Camera System Control Module

• If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine. Use the Vehicle Diagnosis, Testing and Information System (VAS 5051) to do so.

- Switch off all electrical consumers.

- Remove the key.

Removing

- Remove the luggage compartment trim panel on the left side.

- Remove nuts - 1 - and - 3 - (8 Nm).





- Disconnect the connectors - 2 - and - 4 - from the rear view camera system control module (J772) - 5 -.

- Remove rear view camera system control module - 5 - with bracket.

Bracket, Removing

Two retaining brackets are bolted to the rear view camera system control module.

- Remove the screws - arrows - (3 Nm) and remove the bracket.





Installing

- First install bracket.

- Installation of the rear view camera system control module is the reverse of removal.

- Perform calibration. Refer to => [ Rearview Camera System, Calibrating ] Testing and Inspection.

Rearview Camera

- Switch off all electrical consumers.

- Remove the key.

Removing

• The rear view camera (R189) is equipped with a trailing cable. The couplings to the vehicle wiring harness are located at the left below the vehicle tool kit box.

- Remove the rear lid trim panel.





- Remove the screw - 1 - (4 Nm).

- Remove retaining plate - 2 -.

The rear view camera - 3 - is secured to handle trim.

- Remove rear view camera - 3 - with a suitable tool from the grip piece.

- Separate connectors - 1 - and - 2 -.





Installing

- Install in reverse order of removal.

- Close rear lid.

- Perform calibration. Refer to => [ Rearview Camera System, Calibrating ] Testing and Inspection.

A02510259 42110