Rear Window Wiper Motor, Removing and Installing

Rear Window Wiper Motor, Removing And Installing

Removing
- Remove wiper arm.
- Remove lower rear lid trim.







- Disconnect electrical connection - 2 -.
- Disconnect washer fluid hose - 1 - from connecting pipe for spray jet.
- Loosen nuts - arrows - and detach wiper motor.

Installing
Install in reverse order of removal, noting the following:
- Carefully insert rubber grommet into hole in rear window.
- Fluid hose must audibly engage in spray jet connection.
- Switch on ignition.
- Actuate rear wiper and allow wiper motor to move to end position.

CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

- Install lower rear lid trim.
- Adjust wiper arm.

Component - fastener Nm
Wiper motor to rear lid - nut 8