Front Door Window Motor: Service and Repair

Motor For Window Regulator, Removing And Installing

Removing
- Door trim removed.

NOTE:
- Motor for window regulator can be removed or installed in every position of motor or side window.
- Before removing motor, disconnect electrical harness connectors.







- Remove Torx bolts - 2 - T30 and remove motor.

Installing
- When installing, make sure that threaded pins - arrows - are engaged in inner door plate.
- Slide on window regulator motor - 1 - and secure with bolts - 2 -.
- Tightening torque 3.5 Nm

NOTE:
- Only switch ignition on and off after installing motor and connected wires.
- Then move door window upward to stop and keep pressing switch for window regulator for approx. 2 seconds longer.
- This position is the base position and the high-and low-running function is activated.