Selector Lever Cable and Locking Cable, Assembly Overview

Selector lever cable and locking cable, assembly overview, 01V, 5 SPD. A/T AWD





Notes:
^ Do not bend or kink selector lever cable.
^ Lubricate pull ring and ball socket with polycarbamide grease, part no. G 052 142 A2.
1 - Selector lever cable
- Must not be kinked
- Removing and installing
- Adjusting

2 - Lock nuts - 12 Nm
3 - Boot
- For selector lever cable
- Fasten into bottom cover of shift mechanism





4 - Locking clamp
5 - Ignition/Starter Switch
- With ignition key removal lock

6 - Locking cable
- For ignition key removal lock
- Must not be kinked
- Removing and installing
- Adjusting

7 - Hex-bolt - 9 Nm
8 - Clamping screw - 13 Nm
- For selector lever cable
- To adjust, loosen by approximately 1 turn, do not fully remove





9 - Pin
- for selector lever cable
- To remove selector lever cable, pull plastic securing spring on shift mechanism slightly forward and push pin up only as far as necessary

10 - Retaining clip
- for selector lever cable
- Always replace

11 - Pivot
- for selector lever cable to transmission

12 - Hex-bolt, 23 Nm