Transmission, Attaching to Assembly Stand

Transmission, attaching to assembly stand, 01V, 5 SPD. A/T AWD

Special Tools And Equipment:

^ 3457 attachment and holding rig
^ VW 540 holding fixture (only for FWD transmissions) (Not for US/Canada)
^ VW 313 holding fixture
^ VW 309 holding plate
^ V.A.G 1202A Engine Hoist





- Attach the 3457 attachment and holding rig at the transmission housing mounts and secure.
- Bolt the attachment and holding rig to the VW 309 holding plate and place this into the VW 313 holding fixture using a workshop crane.
For transmissions with Front Wheel Drive (FWD), the VW 540 holding fixture can also be used to secure the transmission to the VW 313 holding fixture (Not for US/Canada).





- Secure transmission to VW 540 holding fixture (arrows) and insert in VW 313 holding fixture.

WARNING! The center of gravity of the transmission is located outside the turning center at holding fixture. To turn the transmission, a second technician must hold the transmission housing to prevent back-swing.

Note: Vents for the transmission housing and final drive must be closed before turning a filled transmission on the assembly stand so that the oil pan faces upward.