ATF Lines and ATF Cooler, Cleaning

ATF lines and ATF cooler, cleaning, 01V, 5 SPD. A/T AWD

Special tools and equipment

VAG 1306 drip tray:

^ Hose, approximately 18 mm
^ Compressed air gun, standard
^ Protective glasses

Notes:
^ Always blow compressed air through oil cooler and ATF lines (maximum. 10 mbar) before installing a replacement transmission.
^ When installing ATF lines, insert into transmission or cooler by hand until impact first and then tighten bolts.

WARNING! Wear protective glasses.

- Place V.A.G 1306 drip tray underneath.





- Remove bolt -2-.
- Disconnect ATF lines from transmission.
- Slide a hose with approximately 18 mm diameter onto ATF line -A- and secure with hose clamp. Place the other end of the hose into an appropriate container.
- Blow through ATF line -B- with compressed air gun.
- Change hose from ATF line -A- to ATF line -B- and repeat procedure.
- Replace O-ring -1-.
- Coat O-ring with ATF.
- Insert ATF lines completely into transmission by hand until stop.
- Re-secure ATF lines.
- Then check ATF level and top off.