Low Beam Headlamp Bulb M29 / M31, Replacing

Low Beam Headlamp Bulb M29 / M31, Replacing - From 11.04

Removing
- Turn light switch to position "O".

CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.







- Remove screws - arrows -.
- Remove Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 N80 -1 - at air duct.
- Remove air duct - 2 -.







- Release retaining tab - arrow - and detach housing cover from headlamp housing.







- Remove bulb - 2 - from spring clips - arrows -.
- Disconnect electrical connection - 1 - at low beam bulb.

Installing
Install in reverse order of removal, noting the following:

CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.

- Insert bulb into housing.
- Position bulb at lower spring clip.
- Push bulb beyond resistance of upper spring clips into housing.
- Reconnect electrical connection and close housing cover.