Condenser, Removing and Installing

Condenser, Removing And Installing

Removing
- Discharge refrigerant circuit Refrigerant R134a - Servicing.
- Remove refrigerant lines from condenser.
- Remove air guides between bumper and condenser.
- If applicable, unfasten or remove power steering cooler (not always necessary, depends on vehicle)
- If applicable, unfasten or remove Coolant Fan Control (FC)Control Module J293 (not always necessary, depends on vehicle)
- Disconnect connector from High Pressure Sensor G65 -B -.







- Remove bolts - A - (tightening torque 5 Nm).

Installing

Install in reverse order.
- Check type of seal at connections and refrigerant lines (must be designed for same type of seal).

NOTE: The condenser removed contains refrigerant oil which has to be returned to the refrigerant circuit (together with new condenser). Refrigerant R134a - Servicing.