Rear Lid Lettering (Avant)

Lettering on rear lid (Avant)

NOTE: Outer edges of rear lid and lines extending from lower rear lights are used as reference edges.

Installation:
- Warm vehicle and type designation to room temperature.
- Bonding surfaces must be dry and free from dust and grease.
- Clean outer panel with mineral spirits, treat with silicone remover and rub dry.
- Pull off backing paper and press on characters - 1 -, maintaining pressure for approx. 3 seconds.

Dimensional data for Front-Wheel Drive (FWD) vehicles







- a = 95 mm
- b = 33 mm
- c = 38 mm
- d = 28 mm
- e = 95 mm

Dimensional data for All Wheel Drive (AWD) vehicles







- a = 33 mm
- b = 28 mm
- c = 4 mm
- d = 12.5 mm
- e = 38 mm
- f = 95 mm