Front Door Window Motor: Service and Repair

Motor for window regulator, removing and installing

Removing
- Remove door trim.

NOTE: Motor for window regulator can be removed or installed in every position of motor or side window.

- Disconnect electrical connectors.







- Remove bolts - 2 - and remove motor - 1 -.

Installing
- Ensure threaded pins-arrows-are engaged in door inner panel.
- Slide on window regulator motor - 1 - and secure with bolts - 2 -.
- Attach electrical connector.

NOTE:
- After installing motor, switch ignition on and off again with wires connected.
- Then move door window upward to stop and keep pressing switch for window regulator for approx. 2 seconds longer.
- This position is the base position and the high-and low-running function is activated.