Fuse Block: Service and Repair

Fuse Box, Removing And Installing

Removing
- Remove driver's storage compartment:







- Remove bolts -1 - for fuse box-2-.
- Remove fuse box from center tube for instrument panel.
- Detach wiring harness on center tube for instrument panel and set aside.







- Cut cable tie -1-.
- Release cover for fuse box -arrows-
- Pull fuses from fuse box.







- Pull off retaining strip for connectors -arrows- and remove connectors from fuse box.
- Unclip base -1-.







NOTE: Check the exact assignment for fuse carrier in the current wiring diagram.

Installing
Installation is reverse of removal, paying attention to the following:

NOTE: All cable ties opened or cut during removal must be reinstalled at the same locations during installation.

Tightening torque

Component Nm
Fuse box to center tube for 3
instrument panel