Hydraulic Lines At the Fitting Plate, Removing and Installing

Hydraulic Lines At The Fitting Plate, Removing And Installing

See cleanliness rules.
Hydraulic pump connection chart.

Special tools and workshop equipment required
- 3335 Assembly driver

Removing
- Remove the hydraulic pump.
- Trim of center and side rear panel removed.







- Lift spring washer -1- at the hydraulic lines to be removed (supply and return) using a small screwdriver above the fitting collar and remove.

Installing







- Install the hydraulic line with fitting through the fitting plate.
- Install the sleeve -1- of the assembly driver 3335 over the fitting.
- Slide the spring washer -2- onto the sleeve and press it in using the assembly driver 3335.

NOTE: The spring washer -2- must be pushed completely over the collar at the fitting -1-.









- Coat the sealing ring -3- with hydraulic fluid and slide it onto the fitting.