02J 5-Speed Manual FWD

Transmission oil level, checking





- Remove insulation tray (if fitted) below engine/transmission.
- Remove plug (arrow) to check oil.
- The oil level is correct if the transmission is full to the lower edge of the filler hole.
- Fit plug (arrow).
- When filling with new oil, note the following:
- Remove plug (arrow).
- Top up oil to lower edge of filler hole.
- Fit plug (arrow).
- Start engine, engage gear and allow transmission to turn for about 2 minutes.
- Switch off engine and remove plug (arrow).
- Top up oil to lower edge of filler hole again.
- Fit plug (arrow).