Rear 3-Point Seat Belt For Children's Bench (Avant), Removing and Installing

Rear 3-point Seat Belt For Children's Bench (Avant), Removing And Installing

1 - 3-point inertia-reel seat belt

Removing







- Remove luggage compartment floor trim.
- Remove bolt - 3 - (1x).
- Compress trim piece - 6 - at cut-out below seat belt, and pry off trim piece - 6 - with a screwdriver.
- Remove respective side padding.
- Remove upper C-pillar trim.
- Remove bolt - 8 -.
- Take off guide fitting - 9 - and bushing - 10 -
- Remove screw - 2 -.
- Remove 3-point inertia-reel seat belt - 1 -with anti-twist element - 11 -.







Installing
- Insert belt tensioner - 1 - with anti-twist element - 11 -.
- Install webbing with a 180 degree twist -arrow-as shown in illustration.
- Install belt mounting plate - 4 - parallel to luggage compartment side trim.
- Remainder of installation is carried out in reverse order of removal.
- Make sure 3-point seat belt is not impeded by cables, wires, insulation or the like.

2 - Bolt
- Tightening torque: 55 Nm (41 ft lb)







3 - Bolt
- Tightening torque: 55 Nm (41 ft lb)
4 - Belt mounting plate
5 - Belt webbing
6 - Trim piece for seat belt
7 - C-pillar trim
8 - Bolt
- Tightening torque: 55 Nm (41 ft lb)
9 - Guide fitting
10 - Bushing
11 - Anti-twist element.