Wiring on Back of Molded Headliner (Avant), Routing

Wiring On Back Of Molded Headliner (Avant), Routing







1 - Back of molded headliner
Molded headliner removed (lowered onto seats).
- Disconnect connector - 3 -.
- Disconnect connectors - 9 -.
- Disconnect connector - 2 -.
- Detach adhesive tape - 8 -.
- Unclip wiring ducts - 5 -.
- Guide out wiring harness - 6 - through wiring guide - 7 -.
- When installing, secure wiring for sun visors with adhesive tape - 8 -.







2 - Connector for interior light
3 - Connector for rear interior light 4-Clip
5 - Wiring duct (6x)
6 - Wiring harness
7- Wiring guide
8 - Adhesive tape for securing wiring
9 - Connectors for sun visor light