Quarter Window Regulator: Service and Repair

Rear window regulator, removing and installing

- Remove rear side trim.







- Remove window shaft strips







- Mark position of nuts - 3 -, adjusting screws - 6 - and bolts - 8 -.
- Remove nuts - 3 -.
- Remove bolts - 8 - and remove cover - 2 -.
- Loosen Convertible Top Control Module J256 on right side of vehicle.
- Loosen nuts - 7 - from adjusting screws - 5 -.

NOTE: The lower nuts - 6 - can remain on the adjusting screws - 5 -, the upper ones must be removed.

- Disconnect window regulator motor connector.
- Remove window regulator - 5 - from side panel - 1 -.

Installation is reverse of removal.