Reverse Idler Gear, Removing and Installing

Reverse idler gear, removing and installing





1 - Circlip
2 - Support plate
3 - Reverse idler gear Different versions, assignment
4 - Needle bearing
5 - Thrust washer
6 - Transmission cover
^ With reverse idler gear shaft (arrow)
^ It is not necessary to remove the reverse idler gear shaft to remove the reverse idler gear
^ The reverse idler gear shaft is not available as a replacement part
^ Apply thin coat of sealing paste AMV 188 001 02 to sealing surfaces
7 - Torx bolt - 35 Nm
^ To secure reverse idler gear shaft