Wiring Harness: Service and Repair

5 Spd. A/T 01V
Wiring harness inside transmission, removing and installing
Removing
- Removing valve body.





- Lever out retainer straps of connectors at solenoid valves and pressure control valves using a small screwdriver and disconnect connectors -A- in sequence.
- Unhook wiring harness at side retainer straps -13- of valve body.





- Turn valve body on its back side and loosen connector -1- at Pressure Control Valve 1 for Auto. Transmission -N215-.
- Remove retaining clip (arrow A) and unclip wiring harness from retaining clip (arrow B).

Installing
Installation is reverse of removal, noting the following:
- When installing, connect connectors of wiring harness to the corresponding solenoid valves and pressure control valves.
- Clip wiring harness into the respective retaining clips. In case of deviations, the wiring harness can be pinched during installation of the valve body.
- Installing valve body.
- Fill up ATF.