Oil Line Inside Transmission, Removing and Installing

Oil line inside transmission, removing and installing

Special tools and equipment





- 3381 oil line installer

Notes:
- Faulty O-rings at inner oil fine allow ATF to enter the differential, which becomes over-filled and oil escapes at differential vent.
- A removed oil fine generally must be replaced.
- The oil fine must only be inserted using 3381 oil line installer. Otherwise there is a risk of leaks because of bending of the oil fine.

Removing
- Removing valve body.





- Lever off inner oil line evenly from transmission housing.

Installing
Installation is reverse of removal, noting the following:
- Replace O-rings.





- Insert oil line into 3381 oil line installer.
- Drive oil line into transmission housing by lightly tapping on the 3381 oil line installer up to stop using a plastic mallet.

Notes:
^ The open side of 3381 oil fine installer faces toward the outer wall of the transmission.
^ Do not cant oil fine. Drive in both fine ends uniformly.

- Installing valve body.
- Fill up ATF.
- Check oil level in front final drive.