Power Steering Fluid: Testing and Inspection

Power steering fluid level, checking
- With engine stopped, move front wheels to straight ahead position.

Cold fluid:
- Unscrew cap.
- Wipe over dipstick with a clean cloth.
- Screw in cap hand-tight and unscrew again.

Note: Fluid level is only valid if cap is screwed in completely.





- Check fluid level:
Fluid level must be around MIN mark (up to 2 mm above/below mark).

Warm fluid (to approximately 50°C):
- Check fluid level:
Fluid level must be between MIN and MAX marks.

Note:
^ Fluid must be drawn off if level is above that stated.
^ Check hydraulic system for leaks if level is below that stated. It is not then sufficient to merely top off oil.
^ Hydraulic fluid drained off is not to be re-used.